combination of glass canopy and stainless steel sunshade makes use of

Contact us

cooperationlike@gmail.com

First, thermal insulation performance. Good thermal insulation and thermal insulation performance means that the heat preservation time is long, the working time of the refrigerator at the same temperature is short, and the fuel consumption is also followed, which plays the role of energy saving and emission reduction. Second, light weight and strong structure. The body weight of the box consumes more fuel in the process of transportation; on the contrary, if the body of the box is light, it consumes less fuel in the process of transportation. The right outer plate and the right side of the roof are hydraulically lifted to a position perpendicular to the table to form a sunshade, rain shield, lighting-fixed ceiling and advertising load-bearing surface. The right inner plate (stage board) is folded into two folds, which is used as a stage after being flipped by hydraulic pressure. An extension plate is installed on the left and right side of the stage, and a T-shaped platform is installed in front. The hydraulic system is controlled by DCV battery power supply.

In addition, its adaptability to temperature is relatively poor, only in a temperature suitable for its growth, it can grow and develop normally. So if the climate of your area does not match its growth conditions, then you need to build a greenhouse for it to adjust the temperature of its surroundings. Zucchini can only grow in the range of 15 to 30 degrees Celsius, and the best temperature is about 20 degrees Celsius, so if the temperature drops suddenly, be sure to keep them warm. They can be covered with some thatch or covered with plastic film. When the temperature is high, you can pull the sunshade net for it or increase the ventilation in the garden. This keeps the enzyme in the zucchini at its highest activity, allowing it to grow faster.

At first, the improved locomotive did not have any front windows. After the EF58 electric locomotive was put into operation, the locomotive was modified according to the climatic environment along the line, such as installing an icicle cutting plate above the front window glass to prevent the running locomotive from hitting the icicles falling at the entrance of the tunnel and causing damage to the window. and add a cover to the whistle. In the later period, when the locomotive was transferred to the warmer climate area, the whistle cover of the locomotive was removed, but some locomotives only removed the icicle cutting plate and retained the whistle cover during car body maintenance. In addition, some EF58 electric locomotives in Hiroshima area are also equipped with front window windows, but the purpose is completely different from that of crossing the line, but it is used as a sunshade.

The sunshade and heat preservation system on the top of the greenhouse. In order to improve the adaptability of the system, greenhouse construction manufacturers, so that it can be extended to most of the solar greenhouse built in the northwest, Gansu greenhouse construction, the system uses steel cable drive mechanism. Its working principle is that the motor drives the drive shaft to run, and the tight wire sleeve on the drive shaft turns the circumferential motion into linear motion. The aluminum drive card connected with the drive line drives the driving side aluminum profile to move parallel on the curtain line through the word connection, and the driving edge aluminum profile pulls one end of the curtain slowly to unfold and fold, that is, after all is folded, the opening and closing limiter switch is triggered respectively, the motor stops, and the operation is over.

(3) the combination of glass canopy and stainless steel sunshade makes use of the characteristic that stainless steel is a poor conductor of heat, and takes away the solar radiant heat through the air flow caused by hot pressure and wind pressure between the two, so that the canopy system can play a role of heat insulation. make the building more energy-efficient.

Many car companies do not make these parts themselves, but by supporting manufacturers. The interior design mainly includes dashboard, steering wheel, seat, seat belt, airbag, carpet, sidewall interior decoration, sunshade panel, handrail, car rearview mirror and so on.

Scroll to Top